Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
See the difference
Before
After
Before
After
Before
AfterHow Much Does Chimney Liner & Rebuild Cost in San Leandro?
A chimney liner installation in San Leandro typically costs between $2,400 and $5,800, while a partial chimney rebuild generally runs $3,200 to $9,500 depending on how much brick and crown work is involved. A HeatShield resurfacing job, which restores a liner that isn’t fully failed, usually lands between $1,400 and $2,800 and can postpone a full reline. Final pricing varies by liner length, flue condition, and access, so the written estimate you receive sets the real number.
We’re Chimney Cleaning San Leandro, and we’ve handled the full lifecycle of chimney systems here since 2013. That means we don’t just sweep and hand you a list of problems. We diagnose what’s actually wrong inside the flue and rebuild or reline it on the same visit when the scope allows. Estimates are free.
Key Takeaways
- Stainless liner installation: roughly $2,400 to $5,800 for most residential flues
- HeatShield chimney resurfacing (non-replacement repair): about $1,400 to $2,800
- Partial rebuild with crown and flashing work: $3,200 to $9,500
- We install DuraFlex and Olympia Chimney liners and apply HeatShield, all professional-grade brands
- Free estimates and repair-capable technicians on the same visit as your sweep
Chimney Liner & Rebuild Cost Breakdown (2026)
Here’s how the line items stack up in the San Leandro market for the 2026 season. These are estimates, not a quote. The written estimate from your technician is what fixes your actual price.
| Line Item | Typical Range | What It Covers |
|---|---|---|
| Stainless steel liner install (single flue, standard length) | $2,400 – $5,800 | DuraFlex or Olympia Chimney liner, insulation, top plate, cap connection |
| HeatShield chimney resurfacing | $1,400 – $2,800 | Cast-in-place liner repair when the existing flue is sound enough to reline rather than replace |
| Liner inspection and sizing | Included with a sweep and estimate | Camera check, flue measurement, draft assessment |
| Partial chimney rebuild (upper courses and crown) | $3,200 – $6,400 | Brick replacement, mortar work, crown rebuild, flashing reset |
| Full-height chimney rebuild | $6,800 – $9,500 | Rebuild from the roofline up, with a new crown and cap |
| Chase cover and cap replacement | $450 – $1,100 | Gelco or Copperfield cap and chase components |
| Damper or firebox repair | $350 – $1,200 | Rebuild of firebox panels or damper replacement for wood-burning fireplaces |
What drives the price up or down? The biggest variable is liner length and how much scaffolding or roof access the chimney needs. A straight flue on a single-story house in a San Leandro neighborhood like Estudillo Estates or Davis West is usually faster and cheaper than an offset flue with a chase cover that’s been leaking. A cracked crown and failed flashing add rebuild work that a liner job alone won’t touch. And if the flue has a clay liner that’s still structurally sound, HeatShield resurfacing can save you the cost of a full reline.
We stock and install professional-grade brands – DuraFlex, HeatShield, Gelco, Olympia Chimney, Famco, and Copperfield – so we’re not ordering the cheapest part and waiting on a truck. That matters on a repair the same week a home inspection fires off a flag.
What Affects Chimney Liner & Rebuild Pricing in San Leandro
San Leandro sits in the East Bay with a mild climate that works in your chimney’s favor. Winters are cool and damp rather than freezing, so we don’t see the deep freeze damage that tears apart mortar in colder parts of the country. But the damp air and the occasional winter storm still wear on brick, mortar joints, and crown caps. Here’s what moves the price on any given job.
- Flue condition and liner type. A clay flue with cracked joints may be a candidate for HeatShield resurfacing, which costs less than tearing it out and dropping a stainless liner. A fully failed flue means a full reline with DuraFlex or Olympia Chimney product.
- Chimney height and roof access. Tall chimneys on two-story homes in areas like Broadmoor or Bay-O-Vista need more staging and safety planning, and that shows up in labor.
- Offsets and turns in the flue. A straight run installs faster. A flue with a sharp offset or a damaged smoke chamber takes more time and sometimes a smoke chamber parging step.
- Crown and flashing damage. A cracked crown lets water into the masonry and turns a liner job into a rebuild if it’s been leaking long enough. Fixing it in the same visit saves a second appointment.
- What type of appliance you burn. A wood-burning fireplace and a gas appliance need different liner sizing and venting. The inspection tells us which before we quote.
- Cap and chase cover condition. Rusted Gelco or Copperfield caps and chase covers are often the entry point for water. Replacing them during a liner install avoids a callback.
One thing we see a lot in San Leandro: a home inspection flags a chimney as “needs further evaluation” and the buyer gets nervous. The truth is often that only part of the system is failing. We repair what we find, so you’re not paying for a full rebuild when the flue only needs a resurfacing or a new crown.
How to Save on Chimney Liner & Rebuild in San Leandro
There’s no way to avoid the cost of a real liner failure, but there are smart ways to keep the bill down and avoid paying twice.
- Get the inspection done early. Small cracks and failing mortar are cheap to fix compared to a water-damaged rebuild. A camera inspection during a routine chimney cleaning San Leandro visit catches problems before they spread.
- Ask whether HeatShield is an option. If your flue clay is intact, resurfacing can extend liner life without the cost of full replacement. We’re HeatShield-certified to apply it.
- Fix the crown and cap before the rainy season. Water is the number one cause of masonry failure around here. A crown repair and a new Gelco or Copperfield cap are far cheaper than a rebuild.
- Bundle the sweep, inspection, and repair. Because our technicians diagnose structural issues on the same visit as a cleaning, you’re not paying two separate appointments to get the same answer.
- Don’t skip the dryer vent while you’re at it. Our dedicated dryer vent cleaning with Famco commercial-grade venting is a fire-safety service, not an upsell, and handling it on the same visit saves time.
We give free estimates on every liner and rebuild job. Call (833) 736-8208. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. Estimates are free, and the price is set per job by the written estimate. No service-call fee, no trip charge.
FAQs – Chimney Liner & Rebuild Cost
How much does a chimney liner cost in San Leandro?
A chimney liner installation in San Leandro typically ranges from $2,400 to $5,800 for a standard residential flue, depending on length, offset, and whether insulation is needed. The written estimate fixes the final price. Call (833) 736-8208 for a free quote.
Is it cheaper to repair or replace a chimney liner?
Repair is almost always cheaper when it’s an option. HeatShield resurfacing runs about $1,400 to $2,800 and can extend the life of a liner that’s still structurally sound, while a full DuraFlex or Olympia Chimney reline runs $2,400 to $5,800. The real factor is whether the flue can be resurfaced or is already too far gone. An inspection tells you which applies.
Can you come today for a chimney liner estimate?
We dispatch technicians Sunday through Friday, 7am to 7pm, and same-day visits are often possible. Call (833) 736-8208. We answer 24/7. A call outside dispatch hours is booked into the next opening. Estimates are free.
How much does a chimney rebuild cost in San Leandro?
A partial chimney rebuild typically costs $3,200 to $6,400, and a full-height rebuild runs $6,800 to $9,500. Most of the cost is brick, mortar, crown, and flashing work plus staging and safety for roof access. Call (833) 736-8208 and we’ll give you a free written estimate.
Do I need a permit to rebuild a chimney in San Leandro?
Most cities require a permit for structural masonry work like a chimney rebuild, so ask San Leandro’s building department before work begins. Liner installation rules vary by jurisdiction too. We can talk through what your job likely needs during the estimate. Call (833) 736-8208.
How long does a chimney reline take?
A standard stainless liner install is usually a one-day job when access and flue condition cooperate. A rebuild or a complicated offset flue can take longer. The estimate will tell you the expected timeline before any work starts.
Why We Do the Full Job, Not Just the Sweep
Most chimney companies sweep, hand you a report, and leave you to find a masonry contractor for the repair. We don’t work that way. We carry the same professional-grade brands specified by certified chimney professionals nationwide, from the firebox liner with DuraFlex and Olympia Chimney to the cap and chase with Gelco and Copperfield to the venting with Famco. One visit gets you the full picture, and the repair can often start the same day the problem is found.
If you’re in San Leandro and you’ve got a home inspection flag on your chimney or a flue that’s been smoking back into the house, it’s worth a call before the rainy season makes it worse. Reach out to us at (833) 736-8208. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. Free estimates, upfront pricing, and a written scope before we touch a thing. You can learn more about the neighborhoods we serve across San Leandro.
Pricing reflects the San Leandro market as of 2026. Chimney Cleaning San Leandro offers free estimates – call (833) 736-8208.
What Our Customers Say
"Crown was cracked and taking water. Repaired it rather than quoting a rebuild, which the previous company had pushed hard for."
- Yolanda Vargas"Fireplace had never drawn properly since we moved in. He found the damper was only opening halfway due to a bent linkage and fixed it in ten minutes."
- Kristen Gallagher"Level two inspection before we bought the house. The report was detailed enough to use as a negotiating point and he explained every photo in it."
- Laura Mercer